Use and Care

5
LOCATION OF PARTS
Handle
Half Shelf (Total 1)
Door
Digital Control Panel
Levelling Legs
Security Lock
Interior Light
Full Shelf (Total 3)
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• CAUTION: After unpacking and before connecting the appliance to the power source, you MUST
allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect performance
and the lifetime of this unit.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 7.)
INSTALLATION OF YOUR APPLIANCE
• Your appliance is designed to be either free-standing or built-in (fully recessed). If free standing, the
unit should have at least 4” of clearance at both sides, at the top and at the back to allow for adequate
ventilation. If it is built-in, leave at least 3/16” at both sides, 1/16” at the top and 2” at the rear. Be sure
that airflow under the appliance is not blocked. If installing your appliance inside a cabinet where the
front door may be blocked, call our technical support department at 718-893-3900 ext. 597 for proper
cutout and clearance dimensions.
• WARNING: Do not store or install the appliance outdoors.
• CAUTION
: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
• Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully loaded.
To level the unit, adjust the front leveling legs.
• For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the unit
to allow proper air circulation to cool the compressor and condenser.