Use and Care

INSTALLATION AND CONNECTION

• Remove the exterior and interior packaging before using your appliance.

• Place the washing machine on a clean, dry concrete floor strong enough to support the

machine.

• Let the washing machine stand for at least two hours before first using the appliance.

NOTE: Before using your appliance for the first time, the transport rods must be removed. A

blocked washing machine may be damaged when it is switched on for the first time.

Warranty should be void in cases of such damage.

Removing the Blocking Rods

1. Move the housing and remove the screws on the back of

the washing machine. Remove the two angular

pieces.

2. Slide the angular pieces onto the groove in the

blocking rod. Before doing so, rotate the right

angular piece to the opposite side.

3. Use the angular pieces to rotate the blocking

rods by 90° and pull them out.

4. Cover the two holes, through which the blocking rods were

inserted, with plastic plugs. Redo the screws that were

removed in Step 1.

Adjusting the Washing Machine Feet

Use a water scale and a No.32 wrench to adjust the feet and a No. 17 wrench to adjust the nut.

1. Rotate the adjustable feet to change their height and

level the washing machine.

2. Firmly tighten the jam nuts, using a No. 17 wrench, by

turning them up, toward the bottom of the washing

machine.

NOTE: Incorrect leveling of the washing machine may cause

vibrations, the appliance to slide across the room, or

the washing process may be louder than normal.

Incorrect leveling of the machine is not subject to

warranty.