FELIX STORCH, INC.
Before Putting Into Use Before connecting the appliance to the power supply, leave it standing for about 2 hours, which will reduce a possibility of malfunctions in the cooling system due to transport handling. Clean the appliance thoroughly; especially the interior (See Cleaning and Maintenance). Instructions for Use These instructions for use are intended for the user. They describe the appliance and the correct and safe way to use it.
Important If you bought this appliance to replace an old one equipped with a lock that cannot be opened from inside (lock, bolt), make sure that the lock is broken. This will make it impossible for children to lock themselves inside the appliance and suffocate. The appliance must be correctly connected to the power supply. (See Connecting to the Power Supply). If the food has a strange smell or color throw it away because it is very likely that it is spoiled and therefore dangerous to eat.
Placing the Self-Standing Appliance It is important to make sure the appliance is leveled evenly to prevent falling. Two spacers attached to the appliance must be fitted onto the upper edge of the condenser, thus preventing the appliance from being installed too close to the wall. Spacers are manufactured for all-purpose functions depending on the distance of the condenser from the wall. Therefore turn spacers correspondingly and adjust them accordingly to the appliance.
Use Storing Fresh Foods • Foods to be stored in the freezer should be properly packed as to prevent mixing various moisture degrees and odors (in polyethylene bags or sheet, aluminum foil and covered containers). • Never store any inflammable, volatile or explosive substances. • Food should not touch the rear wall of the freezer. • Some organic solutions like volatile oils in lemon and orange peel, acid in butter etc.
Manual Defrosting of the All-Freezer When the frost and ice layer in the freezer is 1/8” thick you should clean the freezer. • First turn the thermostat knob to the STOP (0) position and disconnect the power supply. Empty the compartment and make sure that the packages remain frozen. • Place a suitable vessel under freezer to collect the defrost water. Leave the freezer door open to accelerate defrosting. Cleaning the Appliance Disconnect the power supply before cleaning the appliance.
Trouble-Shooting Guide During the service of your appliance, you can come across some troubles that in most cases result from improper handling of the appliance that can easily be eliminated. The Appliance Fails to Operate After Connecting to the Power Supply • Check the supply in the outlet socket and make sure the appliance is switched on (thermostat in the operating position). Continuous Operation of the Freezer System • The door was frequently opened or it was left open too long.
Door swing reversal (Stainless steel models with towel bar handles do not have reversible doors.) If you find the direction of opening the door on your appliance inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory 1. Remove the top hinge cover and hinge (on models with a tabletop, remove the bottom hinge instead). 2. Next remove the door and remove the bottom hinge. 3. Then remove the kick plate, slide it over to the opposite side and secure in place. 4.
Noise The cooling in the freezer is enabled by the compressor, this produces noise. How noisy the appliance is depends on where it is placed, how it’s used and how old the appliance is. • During the operation of the compressor, a liquid noise is heard and when the compressor is not operating a refrigerant flow is heard. This is a normal condition and it has no influence whatsoever on the lifetime of the appliance. • Sometimes unusual and strong noises occur which is rather unusual for the appliance.