Owner Manual
7 
INSTALLATION INSTRUCTIONS 
BEFORE USING YOUR APPLIANCE 
  Remove the exterior and interior packing. 
  Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. 
This  will  reduce  the  possibility  of  a  malfunction  in  the  cooling  system  from  handling  during 
transportation. 
  Clean the interior surface with lukewarm water using a soft cloth. 
  Install the handle on the door, if it is not already attached. (See page 9.) 
INSTALLATION OF YOUR APPLIANCE 
  The appliance is designed for built-in or recessed or free standing installation for indoor use for models 
FF1532B, FF64B, FF64BSS, SCFF1533B, SCFF52W, SCFF53B and SCFF53BSS, and outdoor use 
for SPR316OS, SPR627OS and SPFF51OS. 
  CAUTION: This appliance is not designed for the storage of medicine or other medical products. 
  Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the 
unit, adjust the front leveling legs. 
  For free standing installation, 5” (127mm) of space between the back and sides of the unit, and  4” 
(102mm) at the top, are suggested, which allows the proper air circulation to cool the compressor and 
condenser. Even for built-in installation, it is a must to keep ¼” (6.35mm) space on each side and at 
the top and  2” (51mm) at the rear. Take care that the air vent at the front of the appliance is never 
covered or blocked in any way. 
  NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating 
source.  Direct  sunlight  may  affect  the  acrylic  coating  and  heat  sources  may  increase  electrical 
consumption.  Don’t  install  in  a  location  where  the  temperature  will  fall  below  44°F  (7°C).  For  best 
performance, do not install the appliance behind a cabinet door or block the base grille. 
  Avoid locating the unit in moist areas.  
  Plug the appliance into an exclusive, properly grounded wall outlet. 
ELECTRICAL CONNECTION 
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped 
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of 
electrical shock. 
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For 
personal  safety,  this  appliance  must  be  properly  grounded.  Any  questions  concerning  power  and/or 
grounding should be directed toward a certified electrician or an authorized service center. 
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have 
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. 
When a  standard  2-prong  wall  outlet  is  encountered,  it  is  your responsibility  and  obligation  to  have  it 
replaced with a properly grounded 3-prong wall outlet.  
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or 
dangling. 
 WARNING 
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is 
damaged, have it replaced by a qualified electrician or an authorized service center. 










