Use and Care Manual

the internal cabinet temperature. The SET temperature is automatically saved.

Upper chamber: Temperature setting can be adjusted from 41 to 54

F (5 to 12

C).

Lower chamber

To view the SET temperature of either chamber at any time, press the

corresponding SET button. The SET temperature will show in the LED display

for about 5 seconds, then the current internal temperature for that chamber will

reappear.

: Temperature setting can be adjusted from 54 to 72

F (12 to

C).

In the event of a power interruption, all previous temperature settings are

automatically saved and each chamber will keep the previous temperature setting.

(The temperature preset at the factory is 41°F (5°C) for the upper chamber and

54°F (12°C) for the lower chamber.)

This unit has the option to display temperatures in either Fahrenheit or Celsius. To

change the setting, press the °C/°F button. A green light will indicate whether

Fahrenheit or Celsius temperatures are being displayed.

NOTES: If the unit is unplugged or turned off, or if there is a power failure, you

must wait 3 to 5 minutes before restarting the unit. If you attempt to restart

before this time delay, the wine cooler will not start.

When you use the wine cooler for the first time, or restart the wine cooler after it

has been shut off for a long time, there could be a few degrees variation

between the temperature you select and the one indicated on the LED readout.

This is normal and is due to the length of the inactivation time. Once the wine

cooler has been running for a few hours, it should operate normally.

Interior Light

You can turn the interior light on or off by pushing the button marked LIGHT. For

best storage of wine, keep the light off except when viewing.

NOTE: The light goes off automatically after 10 minutes.

Door Lock

This unit can be secured with a lock and key. The keys are located inside the

plastic bag that contains the User’s Manual. Insert the key into the lock and turn it

clockwise to lock the door, making sure the metal pin is engaged completely. To

unlock the door, do the reverse. Remove the key and put it in a secure location.

Defrosting

The wine cooler defrosts automatically during its operating cycle. The water

resulting from the defrosting is collected in a drip tray near the compressor at the

back where it is automatically evaporated. During the defrosting operation, the

displayed temperature may be higher than the set temperature.