ElectricRangesUseCare

21
ALIGNMENTS AND ADJUSTMENTS
Oven Door Spring Adjustments
The oven door springs are properly adjusted before leaving the factory. The springs should
be adjusted to allow the door to remain open when pulled 90 degrees forward and yet pull
the door tight against the oven front frame when closed. If adjustments should become
necessary, remove the storage drawer and grasp spring with fingers, and pull downward.
To give more tension, push toward rear of range and attach in first slot. To make spring
adjustment on ranges without storage drawer, remove false panel and follow the same
procedure.
Make certain all surface elements are
cool and all switches are in the OFF
position prior to seating elements.
Seating Top Elements
The top element may need initial
seating after installation of the stove
or after they have been unplugged and
re-installed. Palm the element as
shown. Pick up on the rear section
with your fingers, while at the same
time, push down on the front of the
element with the palm of your hand.
CAUTION
!
Storage
Your electric range is equipped with a
storage area located beneath the oven cavity.
To access this compartment, gently lift on
the front edge of the “drop-down” panel and
let it fall forward as shown. ONLY LIFT ON
THE FRONT EDGE OF THE PANEL SO
AS TO NOT PINCH YOUR FINGERS. Do
not
use this panel as a step or shelf.