INSTALLATION INSTRUCTIONS BUILT-IN GAS AND ELECTRIC SURFACE UNITS (Cook tops) CABINET OPENING Prepare the cabinet accurately so your unit will fit properly. Below are cabinet cutout dimensions, The dimensions are for the unit to be mounted so the knobs are on the right side. CHECK LOCAL CODES BEFORE MAKING o Overfond CONNECTIONS. 2 o Overhead j Combustible T e Construction SIS “Connection Area 225" (LOUELLA) e ~ 289" {LOOSELY} / “AT" See CABINET PREPARATIONS Section.
GAS SURFACE UNITS MOUNTING THE BUILT-IN TOP UNIT Place unit in cabinet opening with the valves on the right side. Raise the top by removing top burner valve knobs, and lifting upward on the front edge of the main top. Secure unit to top of cabinets with four No. 8 screws through holes provided in the top flanges of the burner box. The gas pressure regulator supplied must be used with this unit If it is necessary to convert this unit from use with natural gas to L.P,, or L.P.
Manifold Pipe and Burner Valves — Top Buber Allots Pilot Adjustment Built-in Top Unit with Pilots {Main Burners Not Shown) On units with battery powered ignition, there are no top burner pilots. There are top ignition electrodes in the same location as the top burner pilots. This ignition system requires one (1) § volt alkaline battery for operation. The battery is housed in an enclosure underneath the switch panel cover. 1t is recommended that you check and/or replace the battery at least once per year.
WIRING DIAGRAM FOR GAS RANGES AND SURFACE UNITS WITH BATTERY EQUIPMENT TEAT ', = F Uprears LED cupric | 5 1 wires arroyo o sy REFER ONLY TO FEATURES WHICH ARE EQUIPPED ON YOUR RANGE 166-6C162 TOP BURNER VALVES Built-in top boomer valves are operated by pressing the knob and turning #t 90 degrees counter-clockwise to the “LITE” position. This position is also the "Hi* position where maximum gas flow is obtained. Hold the knob in this position until the burner successfully lights.
WIRING DIAGRAM FOR GAS SURFACE UNITS AND WALL OVENS BK TOP BURNER IGNITION SWITCHES REAR FRONT IGNITION IGNITION IGNITION MODULE LEAD LEAD OVEN T'STAT OVEN y© N — INHERITOR SAFETY VALVE BK @ M LOOK with TIE |8 @ ()i OVEN LAMP SWITCH \ o/ oven AP WALE PLUG BK.
ELECTRIC SURFACE UNITS MOUNTING THE BUILT-IN TOP UNIT Place unit in cabinet opening with the knobs, on the right side. Raise the top by tilting upward on the rot edge of the main top. Secure unit to top of cabinets with four No. 8 screws through hales provided in the top flanges of the boomer box. Make electrical connection. Electrical connection should conform 1o local requirements and codes.
THREE-WIRE CONDUIT CONNECTION BRANCH i JUNCTION BOX {ACCESS PLATE BLACK REMOVED) LEAD RED LEAD WHITE LEAD . Remove the access plate to gain access 1o the electrical junction box. 2. Install the thees-wire range conduit and an appropriate strain relief clamp through the Tole in the junction box. . Usc an appropriate insulated wire connector 1o connect the red and black wires from the range conduit to the corresponding ved and black chads from the branch circuit. 4.