Operator's Manual

Rev. 0 7/16/2020
27
Summus Medical Laser, LLC 1185 West Main St. Franklin, TN 37064 TEL: [phone]
The hand piece connector is located directly above the device. Remove the
handle and laser port dust cap before installing the handle. Gently insert the
handle connector into the laser port and tighten it by turning the fastening nut
clockwise. Remove the black protective cap and place into case. Select the
treating head and screw it to the base of the hand piece.
Insert fiber into laser port and
screw it until fastened tight.
Remove black protective cap
and place into case.
Select the treating head, and
connect to base of hand
piece.
Power Requirements
Platinum Series P4H Diode Laser has two power supplies: external adapter
power supply and internal battery. Keep the device at least 20cm away from the
wall to ensure smooth ventilation during work and facilitate the operation of the
power switch. Press the power switch to the ON position to start the device.
External power supply: Directly insert the adapter plug specified by our
company into the DC jack of the rear panel of the device.
External adapter
Internal battery