Instructions / Assembly

3
MATERIAL
Your kayak is manufactured from High Density Polyethylene (HDPE). It is a very durable material. Our specially formulated HDPE has
an ultra-violet inhibitor blended throughout the material to reduce color fade and maintain its strength. Polyethylene is a somewhat
flexible material with some memory. This means it has a tendency to return to its original molded shape if distorted. All boats are
equipped with foam for flotation.
BOAT SET-UP
Note: Models vary and may not come equipped with the features listed below.
Adjustable Foot Braces
Raise the foot brace handles and adjust foot braces to desired position. Lower handles to lock in position.
Adjustable Seat Back
Unhook strap fasteners from eyelets. Adjust straps to desired position. Lock fasteners back into eyelets.
Paddle Holder
Paddle can be secured in bungee paddle straps on side of hull. The paddle holder for 8’ Sit-In models is molded into the kayak.
Drain Plug
Make sure drain plug is secure.
Manufacturers Statement of Origin (MSO)
You should receive a MSO with your new boat. Some states may require a MSO for proper registration of your boat. Please check
with your local licensing bureau.
APPLYING REGISTRATION DECALS
Before applying boat registration decals (if required), clean the area with alcohol or any solvent that does not leave a residue. Make
sure the solvent is put aside and the decal area is dry. Using a propane torch, lightly pass the flame back and forth over the area
where the decals will be applied. Don’t try to heat the surface. This procedure will enhance the adhesion of the decals.