Instruction Manual

5 of 7
Programming Instructions
STEP 3: ADVANCED PROGRAMMING (CONTINUED)
SPEED ADJUSTMENT
Each motor has three speeds. To move between the different speeds, follow the diagram below.
Motor
beeps
1X
PRESS
P2
Motor jogs
1X
Gear Down
Gear Up
Motor jogs 1X
Motor jogs 1X
Motor jogs 1X
Motor jogs 1X
PRESS
PRESS
PRESS
PRESS
Motor
beeps
1X
Motor
beeps
1X
Motor
beeps
2X
Motor
beeps
2X
TILT MODE INCREMENTAL MOVEMENT
Tilt mode is used to move the shade in small increments for fine adjustment. It is most
effective when programmed with a standard remote (button remote). Follow the steps
below to set the shade in tilt mode or remove shade from tilt mode.
Recommended with:
Interlude
/ Banded
Illusions
/ Sheer
TILT MODE WILL REMAIN ACTIVE IN ALL MODES
(Except Step 2: Basic Programming) UNLESS REMOVED
SETTING TILT MODE
Motor
beeps
1X
PRESS
Motor jogs 1X
Setup is
complete
until motor jogs 1X
HOLD TOGETHER
DELETING TILT MODE
Motor
beeps
3X
PRESS
Motor jogs 2X
Setup is
complete
until motor jogs 1X
HOLD TOGETHER
Test shade: press the up or down buttons repeatedly for fine adjustment. To move shade automatically,
hold the up or down buttons and release once the shade begins to move.