Replacement Part List
15
2. Take o the bar sheath.
3. Make sure the guide bar is not touching the ground or
any other object.
4. Hold the pole chain saw rmly with both hands.
5. To turn the tool ON, push and hold the safety lock button
with your thumb and then squeeze the On/O switch with
your ngers. Once the tool is running, you can release the
safety lock button and proceed with operation (Fig. 21).
NOTE: Do not press the On/O switch until you are ready
to make a cut.
6. To turn the tool OFF, release the trigger switch.
7. Lift the push lock button and pull out the battery.
Adjusting the Telescoping Pole
The pole chain saw is equipped with two telescoping poles
controlled by two separate cam-locks that work in the same
way. To adjust the telescoping pole, follow the instructions
below:
1. Turn o the On/O switch.
2. Unclip the upper cam-lock to release the pole (Fig. 22).
3. Extend the pole to the desired length (Fig. 23).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb to be cut.
4. Lock the pole in position by closing the cam-lock (Fig. 24),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
mWARNING! Failure to lock the telescopic pole cam-lock
as directed could result in personal injury.
5. If needed, unclip the lower camlock and pull the poles
away to extend the second telescoping pole. Close the
lower cam-lock to lock the pole.
Tightening the Bolt
The retaining bolt may need tightening to secure the
telescoping pole in place.
1. Unclip the cam-lock. Using a hex key wrench, tighten the
cam-lock nut, then close the cam-lock. Ensure that the
pole is secure. The wrench may be required to loosen the
cam-lock nut if you need to adjust the pole to a dierent
height (Fig. 25).
Fig. 21
Safety lock button
On/O switch
Fig. 22
Upper cam-lock
Fig. 23
Telescopic pole
Fig. 24
Cam-lock