Use And Care Manual

11
Set the Swivel Angle
Dierent chains have dierent swivel angles for sharpening.
The specic information should be obtained from the
manufacturer of the chain.
The adjusting knob of the swivel angle is on the bottom of
the machine and allows the grinding table to swivel generally
from -30 to 30 degrees. To adjust the swivel angle, follow the
instruction below.
1. Loosen the swivel angle adjusting knob for setting the
swivel angle (Fig. 7).
2. Set the desired grinding angle by rotating the grinding
table by hand. Use the scale below the grinding table to
get the desired angle (Fig. 7).
3. Tighten the swivel angle adjusting knob. Make sure the
grinding table is locked securely (Fig. 7).
Adjust the Chain Stop
If the grinding wheel is not touching the chain tooth that needs
to be sharpened when the motor head assembly is folded down,
move the chain stop as indicated below.
1. Loosen the chain stop locking knob so the chain stop
adjusting knob can be screwed by hand (Fig. 8).
Rotate the chain stop adjusting knob to move the chain
stop (Fig. 9).
2. During adjusting, fold down the motor head assembly to
see if the grinding wheel touches the tooth (Fig. 10).
3. When the chain stop is in the correct position, lock the
chain stop locking knob and make sure the chain stop will
not move anymore (Fig. 8).
4. Flip the chain guide lock to the lock position. Make sure
the chain is hold securely (Fig. 11).
Fig. 6
Chain stop
Chain guide
Chain
tooth to be
sharpened
Fig. 7
Swivel angle
adjusting knob
Tighten
Loosen
Grinding table
Scale
Fig. 8
Chain stop
locking
knob
Unlock
Lock
Fig. 9
Chain stop
adjusting knob
Forward
Backward
Fig. 10
Motor head
assembly
Grinding
wheel
Chain
tooth to be
sharpened
Touching