Operating Guide

10
mCAUTION! FIRE HAZARD. When remove the batteries
from the charger, be sure to unplug the charger from the outlet
rst, then remove the batteries from the charger.
mWARNING! This charger does not automatically turn
o when the batteries are fully charged. Please take care not
to leave the batteries in the charger. Switch o or unplug the
charger at the mains when charging is complete.
7. Timely recharging of the batteries will help prolong the
batteries' life. You must recharge the battery packs when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to
the batteries.
Charging a Hot or Cold Battery Pack
The green indicator lights on the charger base indicates that
the battery packs' temperatures are outside the charging
range. Once the packs are within the acceptable range, normal
charging will take place and the red light will be continuous.
Hot or cold battery packs may take longer to charge.
Assembly
m
WARNING! Do not insert the batteries until assembly is
complete. Failure to comply could result in accidental starting
and serious personal injury.
mWARNING! Before performing any maintenance,
make sure the batteries and the safety key are removed from
the unit. Failure to heed this warning could result in serious
personal injury.
mWARNING! The product must be fully assembled
before operation. Do not use a product that is only partially
assembled or assembled with damaged parts.
NOTE: Before using the mower, follow these instructions to
assemble the handle and grass bag.
Handle Assembly
1. The unit arrives with the lower handle in the storage
position and the upper handle detached. Lift the lower
handle to the desired height and tighten the preassembled
knobs. (Fig. 5).
2. Fit the upper handle onto the lower handle. Insert the
provided bolts into the aligned holes on the handles and
secure the knobs onto the bolts (Fig. 6).
Grass Collection Bag Fitting
1. Lift the ejector ap up, and remove the mulching plug
inserted in the rear discharge opening.
2. With the ejector ap lifted up, hold the grass collection
bag by the handle and hook it in from above onto the
hooks on both sides (Fig. 7).
Fig. 4
Push lock
button
Fig. 5
Lower
handle
frame
Preassembled
knobs
Fig. 6
Upper handle
frame
Knob
Bolt