Replacement Part List

9
Charger Operation
m
WARNING! Charge only iON+ 24V lithium-ion battery
packs with their compatible iON+ 24V lithium-ion charger.
Other types of batteries may cause personal injury
and damage.
To reduce the risk of electric shock, do not allow water to ow
into the charger's AC/DC plug.
When to Charge the iON+ 24VBAT
Lithium-Ion Batteries
NOTE: The iON+ 24VBAT lithium-ion battery packs do
not develop a "memory" when charged after only a partial
discharge. Therefore, it is not necessary to run down the
battery packs before placing them into the charger.
• Use the battery charge indicator lights to determine when to
charge your iON+ 24VBAT lithium-ion battery packs.
• You can "top-o" your battery packs' charge before starting
a big job or after a long day of use.
Charging the Batteries
1. Open the battery compartment cover to expose the
battery packs inside. Press the push lock buttons on the
batteries to pull the battery packs out of the equipment
(Fig. 1).
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, two green lights will illuminate and
stay green (Fig. 2).
3. Place the battery packs into the charger by sliding the
packs to lock them into position. When you insert the
batteries into the charger, the two green lights will go
o, and the red lights will illuminate to indicate that the
batteries are charging (Fig. 3).
4. When the charger lights turn green, the batteries are fully
charged (Fig. 3).
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in
1 hr 50 min (between 32ºF/0ºC and 113ºF/45ºC).
5. If the light indicators do not come on at all, check that
the battery packs are fully seated into the bay. Remove
the battery packs and reinsert. If the problem persists,
contact an authorized Snow Joe
®
+ Sun Joe
®
dealer or
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the batteries from the
charger by pressing the push lock buttons and sliding the
batteries backward to unlock them from the charger
(Fig. 4).
Fig. 1
Battery
Push lock button
Push lock
button
Fig. 2
Charger
green
Power on
Fig. 3
Battery packs
red
Charging
green
Fully
Charged