Replacement Part List

ManualsBrandsSun Joe ManualsCordless Hedge Trimmers48-Volt iON+ Cordless Hedge Trimmer (Tool Only)

, LLC

SAVE THESE INSTRUCTIONS

A Division of Snow Joe

, LLC

OPERATOR’S MANUAL

Model 24V-X2-24HT-CT Form No. SJ-24V-X2-24HT-CT-880E-M

CORDLESS HEDGE TRIMMER – TOOL ONLY

48 V MAX* | 24-INCH

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Always follow these safety guidelines. Failure to do so may

result in serious bodily injury or death.

General Power Tool Safety

Warnings

m WARNING Read all safety warnings and all

instructions. Failure to follow the warnings and instructions

may result in electric shock, re and/or serious injury.

Save all warnings and instructions for future reference.

The term "power tool" in the warnings refers to your mains-

operated (corded) power tool or battery-operated (cordless)

power tool.

mDANGER! This indicates a hazardous situation, which,

if not followed, will result in serious injury or death.

mWARNING! This indicates a hazardous situation, which,

if not followed, could result in serious injury or death.

mCAUTION! This indicates a hazardous situation, which,

if not followed, could result in minor or moderate injury.

Work Area Safety

1. Keep work area clean and well lit – Cluttered or dark

areas invite accidents.

2. Do not operate power tools in explosive atmospheres,

such as in the presence of ammable liquids, gases

or dust – Power tools create sparks which may ignite the

dust or fumes.

3. Keep children and bystanders away while operating a

power tool – Distractions can cause you to lose control.

Electrical Safety

1. Power tool plugs must match the outlet. Never modify

the plug in any way. Do not use any adapter plugs with

earthed (grounded) power tools. Unmodied plugs and

matching outlets will reduce risk of electric shock.

2. Avoid body contact with earthed or grounded

surfaces, such as pipes, radiators, ranges and

refrigerators – There is an increased risk of electric shock

if your body is earthed or grounded.

3. Do not expose power tools to rain or wet conditions

– Water entering a power tool will increase the risk of

electric shock.

4. Do not abuse the cord. Never use the cord for

carrying, pulling or unplugging the power tool. Keep

cord away from heat, oil, sharp edges or moving parts.

Damaged or entangled cords increase the risk of electric

shock.

5. When operating a power tool outdoors, use an

extension cord suitable for outdoor use. Use of a cord

suitable for outdoor use reduces the risk of electric shock.

6. If operating a power tool in a damp location is

unavoidable, use a residual current device (RCD)

protected supply. Use of an RCD reduces the risk of

electric shock.

Personal Safety

1. Stay alert, watch what you are doing and use common

sense when operating a power tool. Do not use a

power tool while you are tired or under the inuence

of drugs, alcohol or medication – A moment of

inattention while operating power tools may result in

serious personal injury.

2. Use personal protective equipment. Always wear eye

protection – Protective equipment such as dust mask,

non-skid safety shoes, hard hat, or hearing protection

used for appropriate conditions will reduce personal

injuries.

3. Prevent unintentional starting. Ensure the switch is in

the o-position before connecting to power source

and/or battery packs, picking up or carrying the tool.

– Carrying power tools with your nger on the switch or

energizing power tools that have the switch on invites

accidents.

4. Do not overreach. Keep proper footing and balance at

all times – This enables better control of the power tool in

unexpected situations.

5. Dress properly. Do not wear loose clothing or jewelry.

Keep your hair, clothing and gloves away from moving

parts – Loose clothes, jewelry or long hair can be caught

in moving parts.

6. Remove any adjusting key or wrench before turning

the power tool on – A wrench or a key left attached to

a rotating part of the power tool may result in personal

injury.

Summary of content (16 pages)

PAGE 1
R OPERATOR’S MANUAL A Division of Snow Joe®, LLC CORDLESS HEDGE TRIMMER – TOOL ONLY 48 V MAX* | 24-INCH Model 24V-X2-24HT-CT IMPORTANT! refrigerators – There is an increased risk of electric shock if your body is earthed or grounded. Safety Instructions 3. Do not expose power tools to rain or wet conditions – Water entering a power tool will increase the risk of electric shock. All Operators Must Read These Instructions Before Use 4. Do not abuse the cord.
PAGE 2
7. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used – Use of dust collection can reduce dust-related hazards. 4. Under abusive conditions, liquid may be ejected from the batteries; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from a battery may cause irritation or burns. 8.
PAGE 3
8. Use the hedge trimmer and accessories in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended use could lead to a hazardous situation. – whenever leaving the product unattended; 9. Keep all power cords and cables away from cutting area. Power cords or cables may be hidden in hedges or bushes and can be accidentally cut by the blade.
PAGE 4
Battery & Charger Safety Instructions 6. Plan your work schedule to spread any high vibration tool use across a longer period of time. Emergency Familiarize yourself with the use of this product by means of this instruction manual. Memorize the safety directions and follow them to the letter. This will help to prevent risks and hazards. NOTE: This unit is the tool only. The batteries and the charger are not included. They must be purchased separately.
PAGE 5
Information about the batteries • Do not use an extension cord unless it is absolutely necessary – Using the wrong, damaged or improperly wired extension cord poses a risk of fire and electric shock. If an extension cord must be used, plug the charger into a properly wired 16 gauge or larger extension cord with the female plug matching the male plug on the charger. Make sure that the extension cord is in good electrical condition. 1.
PAGE 6
Information about the charger and the charging process 3. Do not use the cordless tool or the battery charger near vapors and flammable liquids. 4. Use the battery charger and cordless tools only in dry conditions and at an ambient temperature of 41ºF – 105°F (5°C – 40.5°C). 1. Please check the data marked on the rating plate of the battery charger. Be sure to connect the battery charger to a power supply with the voltage marked on the rating plate. Never connect it to a different mains voltage. 5.
PAGE 7
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand, and follow all instructions in the user manual(s) before attempting to assemble and operate. SAFETY ALERT – Indicates a precaution, a warning, or a danger.
PAGE 8
Know Your Cordless Hedge Trimmer Read the owner’s manual and safety instructions carefully before operating the cordless hedge trimmer. Compare the illustration below to the cordless hedge trimmer in order to become familiar with the location of the various controls and adjustments. Save this manual for future reference. 1. Blade cover 2. Safety guard 7 6 3. Secondary switch 4. Front handle 5. Battery compartments (2) 6. Handle lock button 5 4 1 3 7. Rear handle 2 8. Safety button (2) 9.
PAGE 9
Unpacking Carton Contents Lights • Cordless hedge trimmer • Blade cover Light Indicators Charge level button • Manuals with registration card The battery is at 30% capacity and requires charging NOTE: In order to operate this cordless hedge trimmer you will need iON+ 24V System batteries and chargers. See page 15 for battery options and specifications, or visit sunjoe.com. The battery is at 60% capacity and requires charging soon 1.
PAGE 10
Fig. 1 3. The battery indicator LEDs will illuminate one by one during the charging process. Unplug the charger immediately when the 3 LEDs are all illuminated. Push lock button Battery Compartment 2. Depending on your Snow Joe® + Sun Joe® charger model, how to recharge your lithium-ion batteries will vary. You may either insert your 24-volt batteries into the 24VCHRG-QC Quick Charger (sold separately) or the 24VCHRG-DPC Dual Port Charger (sold separately) (Figs. 2 – 3). Fig. 2 4.
PAGE 11
Holding the Trimmer 2. Press and hold the handle lock button, and rotate the rear handle clockwise or counterclockwise as needed (Fig. 5). Before operating the hedge trimmer, stand in the operating position and perform the following checks: Fig. 5 1. You are wearing all of the necessary personal protective equipment, including protective gloves, non-slip footwear, safety goggles, ear defenders, and close-fitting clothing. 2. You are holding the unit firmly with both hands.
PAGE 12
2. To start the tool, hold the tool as described in figs. 7A,7B & 7C, then press and hold the safety button on either side, and squeeze the On/Off switch and secondary switch at the same time. Wait for the tool to reach a stable speed, and release the safety button (Fig. 7). Fig. 7 Safety button (on both sides) On/Off switch • Always cut stems or twigs that are less than 0.7 inch (1.8 cm) thick. Use a non-powered hand saw or pruning saw to trim large stems.
PAGE 13
Care + Maintenance mATTENTION! Before performing any cleaning or maintenance, remove the batteries from the battery compartment. Never touch the moving blades. Sharpening the Blades The blade must be re-sharpened if cutting performance and behavior begin to deteriorate (i.e. if blades frequently snag on branches). 1. Start the hedge trimmer, then stop when the cutter blade and the guard are slightly offset. This will allow clearance for the file between cutter teeth and guard teeth (Fig. 15).
PAGE 14
covering the product with a suitable cloth or enclosure to protect it against dust. Recycling + Disposal The product comes in a package that protects it against damage during shipping. Keep the package until you are sure that all parts have been delivered and the product is functioning properly. Recycle the package afterwards. WEEE symbol. Waste electrical product should not be disposed of with household waste. Please recycle where facilities exist.
PAGE 15
Optional Accessories mWARNING! ALWAYS use only authorized Snow Joe ® + Sun Joe® replacement parts and accessories. NEVER use replacement parts or accessories that are not intended for use with this hedge trimmer. Contact Snow Joe® + Sun Joe® if you are unsure whether it is safe to use a particular replacement part or accessory with your hedge trimmer. The use of any other attachment or accessory can be dangerous and could cause injury or mechanical damage. Accessories 1 Item Model iON+ 24V 2.
PAGE 16
SNOW JOE® + SUN JOE® CUSTOMER PROMISE ABOVE ALL ELSE, Snow Joe, LLC (“Snow Joe”) is dedicated to you, our customer. We strive to make your experience as pleasant as possible. Unfortunately, there are times when a Snow Joe®, Sun Joe®, or Aqua Joe® product (“Product”) does not work or breaks under normal operating conditions. We think it’s important that you know what you can expect from us. That’s why we have a Limited Warranty (“Warranty”) for our Products.