Replacement Part List

10
Replacing the Tine Cylinder
When your AJ800E's raking performance diminishes, it's time
to replace the tine cylinder to get your dethatcher back in
optimal working order. The replacement tine cylinder (Model
AJ800ETNS) is available online for purchase at snowjoe.com.
mWARNING! Before performing any maintenance, always
disconnect the power supply to the unit and wait until the tine
cylinder comes to a complete stop. Wear protective gloves
when handling the tines.
1. Turn the unit over. Using an 8 mm Allen wrench, unfasten
the screw on the right side of the tines (Fig. 9).
2. Lift the screw and the bearing block cover to expose the
bearing (Fig. 10).
3. Wearing protective gloves, grasp the right side of the
cylinder shaft. Lift the cylinder out until it reaches the top
half of the bearing block cover, then slide it to the right to
disengage it from the motor drive (Fig. 11).
4. Carefully remove the new tine cylinder from the box.
You will notice that this cylinder is equipped with twenty-
four spring steel raker tines to maximize the raking
performance of your dethatcher. To install the new
cylinder, slide the square end of the tine cylinder into the
motor drive, seat the bearing into the bearing block, fold
down the bearing block cover and refasten the screw with
the 8 mm Allen wrench (Fig. 12).
NOTE: If you have any questions, please call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-766-9563
(1-866-SNOWJOE) for assistance.
Power Cord
• If the appliance cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualied
personnel in order to avoid a safety hazard.
Fig. 9
8 mm Allen wrench
Fig. 10
Bearing block cover
Screw
Bearing
Fig. 11
Motor
Fig. 12