Replacement Part List

To convert the unit, follow the instruction below:
1. To convert the grass trimmer to an edger, slide the
converting switch on the trimmer head up, meanwhile turn
the lower part of the trimmer head to the side until the
trimmer head is locked into position (Fig. 45).
2. Release the converting switch to lock the edger in place.
Press the rotating buttons on both sides to adjust the
head angle if needed.
3. To convert the edger to a grass trimmer, slide the
converting button on the edger head up, meanwhile turn
the lower part of the edger head to the side until the head
is locked into position (Fig. 46).
4. Release the converting switch to lock the grass trimmer in
place. Press the rotating buttons on both sides to adjust
the head angle if needed.
Operation Tips
• Wear non-slip gloves for maximum grip and protection.
• For the best cutting action against walls, fences, and in
high grass, move the grass trimmer slowly so grass is cut
with the tip of the high speed nylon line.
• Avoid dragging the grass trimmer and string spool hub in
contact with the ground.
• Trim only when grass and weeds are dry.
NOTE: As the weather becomes cooler, the tendency for the
nylon line to break becomes greater. DO NOT USE WHEN
TEMPERATURE IS BELOW 50ºF (10ºC).
• Cut tall grass from top down. This will prevent grass from
wrapping around the shaft housing and string head which
may cause damage from overheating.
• If grass becomes wrapped around the string head:
Stop the grass trimmer.
Remove the battery.
Remove the grass.
• Hold the grass trimmer with your right hand on the rear
handle and your left hand on the auxiliary handle. The grass
trimmer should be held at a comfortable position with the
auxiliary handle about hip height.
To use the edger guide/ower guard, ip it down from its
stored position (Fig. 47).
mWARNING! Always hold the trimmer away from
body. Any contact with the grass trimmer cutting head while
operating can result in serious personal injury.
• The life of your nylon line is dependent upon following
instructions for proper use, as well as what is being cut,
and where the cutting is being done.
mWARNING! Remove stones, loose pieces of wood, and
other objects from the cutting area. The string continues to
rotate for a few seconds after switching o the trimmer. Let the
motor come to a complete stop before resuming operation. Do
not rapidly switch the trimmer o and on.
Fig. 45
Grass trimmer Edger
Converting
switch
Fig. 46
Grass trimmerEdger
Converting
switch
Fig. 47
Edger guide/ower guide
23