Replacement Part List

8
Sharpening the Blades
The blade must be re-sharpened if cutting performance and
behavior begin to deteriorate (i.e. if blades frequently snag on
branches).
1. Stop the motor and disconnect the unit from the power
supply. Clamp the blade in a vise.
2. File the exposed cutting surface of each blade tooth with
a smooth round le. Be sure to retain the original angle of
the tooth when ling.
3. Remove the blade from the vise, and power on the motor
until the unsharpened edges of the remaining blade teeth
are exposed.
4. Disconnect the hedge trimmer from the power supply and
repeat the sharpening procedure as necessary.
mWARNING! Do not operate the hedge trimmer with dull
or damaged cutting blades. This may cause overload and will
give unsatisfactory cutting results.
Cleaning the Hedge Trimmer
1. Stop the motor and disconnect the unit from the power
supply.
2. Clean dirt and debris from the body of the hedge trimmer
using a damp cloth and mild detergent.
NOTE: Do not use any strong detergents on the plastic
housing or the handle. These parts can be damaged by certain
aromatic oils such as pine and lemon, and by solvents such as
kerosene.
Storage
1. Always place the blade cover on the blade before storing
or transporting the hedge trimmer. Use caution to avoid
the sharp teeth of the blade.
2. Clean the hedge trimmer thoroughly before storing.
Store the hedge trimmer indoors, in a dry place that is
inaccessible to children. Keep away from corrosive agents
such as garden chemicals and de-icing salts.
Service + Support
If your Sun Joe
®
Hedger Joe electric hedge trimmer requires
service or maintenance, please call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Model + Serial Numbers
When contacting the company or reordering parts, you will
need to provide the model and serial numbers of your product.
These are found on the decal axed to the housing or handle
of your electric hedge trimmer. Copy these numbers into the
space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
Serial #:
H J 2 2 H T E
Troubleshooting
Most diculties are easy to x. Consult the troubleshooting table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor adjustments, please call 1-866-SNOWJOE (1-866-766-9563) for
assistance.
Troubleshooting Table
Possible Cause
• Extension cord not connected to the
power plug
• Extension cord not connected to
power source
• Hand safety switch not fully
engaged
• Dry, corroded blades
• Blades or blade support bent
• Bent or damaged teeth
• Loose blade bolts
Problem
• Unit does not run
• Slow running, noisy, or hot blades
Possible Solution
• Check extension cord is fully
connected to tool
• Check extension cord is fully
connected to a live receptacle
• Check safety switch is fully
depressed prior to pressing trigger
switch
• Lubricate blades
• Straighten blade or blade support
• Straighten teeth
• Tighten blade bolts