Use and Care Manual

15
on the rear handle and left hand on the front handle with
thumbs and ngers encircling the respective handles. A rm
grip combined with proper positioning of the handle against
your body will help you maintain control of the saw. Do not let
go of the saw while it is in operation.
mWARNING! Do not operate the cordless chain saw in
a tree, on a ladder, or on a scaold. Using the tool under such
circumstances is extremely dangerous.
mCAUTION! The chain will continue to run for several
seconds after turning o the tool.
Do not use the chain saw under wet conditions. Use extreme
caution when cutting small brush, saplings, or limbs under
tension because slender and tense material may catch the
saw and be whipped toward you, pull you o balance, or
spring back.
Do not use the chain saw to cut vines and/or small underbrush.
mWARNING! Do not let familiarity with this type of tool
prevent you from taking all necessary precautions. Remember
that a careless fraction of a second is sucient to inict
serious injury.
mWARNING! Do not cut trees near electrical wires.
mWARNING! Failure to lubricate the chain will cause
damage to the bar and chain. Use only a good quality bar
and chain oil designed specically for use with chain saws.
NOTE: It is normal for oil to seep from the saw when not in
use. To prevent seepage, empty the oil tank after each use.
When storing the unit for a long period of time (3 months or
longer), be sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
1. Prior to each cutting session, run through the daily
checklist (see pg. 21).
2. In the event of an accidental activation, reset the safety
brake function by returning the front hand brake to the
operating position. (Fig. 20).
3. Insert the battery in the battery compartment (Fig. 21).
3. To turn the tool on, hold the chain saw rmly with both
hands on the handles. Press the safety lock button, then
push the On/O switch. When the chain saw is running,
you can release the safety lock button (Fig. 22).
4. To turn the tool o, simply release the On/O switch, and
push the front handle brake to the brake position.
NOTE: Do not press the On/O switch until you are ready
to make a cut.
Operating Tips
mWARNING! For your safety and that of others:
1. Do not use the machine without reading the instructions
carefully. Become acquainted with the controls and
the proper use of the machine. Learn how to stop the
machine quickly.
2. Keep in mind that the operator or user is responsible
for accidents or hazards occurring to other people or
their property.
3. Always wear suitable clothing when using the machine.
Wear anti-vibration gloves and other personal
protective equipment.
All the above-mentioned precautions do not, however,
guarantee the prevention of certain risks – i.e. Raynaud’s
phenomenon or Carpal tunnel syndrome. For operators
who use this machine for prolonged periods, it is therefore
recommended to have periodic checkups on their hands
and ngers. If any of the above mentioned symptoms
should appear, please contact a physician immediately.
4. Work only in daylight or good articial light.
Fig. 20
Operating position
Brake position
Front handle
brake
Fig. 21
Battery compartment
Battery pack
R
Fig. 22
On/O
switch
Safety lock button