Replacement Part List

ii) When the log is supported on one end (Fig. 19B), cut 1/3

the diameter from the underside (underbuck). Then make

the nished cut by overbucking to meet the rst cut.

iii) When the log is supported on both ends (Fig. 19C), cut

1/3 the diameter from the top (overbuck). Then make the

nished cut by underbucking the lower 2/3 to meet the

rst cut.

iv) It is easier to saw a log using the spiked bumper

(Fig. 19D).

– Dig the spiked bumper into the log and use it as a

pivot. Cut with an arched motion to make the bar

penetrate the wood.

– Repeat several times if necessary, changing the point

where you plant the spiked bumper.

– When bucking on a slope, always stand on the uphill

side of the log (Fig. 20). When “cutting through” the

log, maintain control by releasing the cutting pressure

near the end of the cut without relaxing your grip on

the chain saw handles. Do not let the chain contact

the ground.

After completing the cut, wait for the saw chain to stop before

you move the chain saw. Always stop the motor before moving

from tree to tree.

End of Operations

When you have nished your work:

• Switch o the motor and remove the battery from its

housing.

• Wait for the chain to stop and allow the machine to cool.

• Remove any traces of sawdust or oil deposits from the

chain.

Fig. 19B

Fig. 19C

Fig. 19D

Fig. 20