Replacement Part List

19
Bar Maintenance
To avoid asymmetrical wear on the bar, make sure it is turned
over periodically.
To keep the bar in perfect working order, proceed as follows
(Fig. 23):
• Grease the bearings on the nose sprocket.
• Clean the bar groove.
• Clean the lubrication holes.
• With a at le, remove burr from the edges and level o
the guides.
Replace the bar whenever (Fig. 23):
• the groove is not as deep as the height of the drive links
(which must never touch the bottom);
• the inside of the guide is worn enough to make the chain
lean to one side.
You can purchase replacement parts for your iON16CS-CT
chain saw by ordering online at snowjoe.com or, to order by
phone, contact Snow Joe
®
+ Sun Joe
®
customer service at
1-866-SNOWJOE (1-866-766-9563).
If it should be necessary to turn the bar over or replace it,
follow the instructions below (Fig. 24):
• carefully remove the casing, the chain, and the bar;
• remove the screw using a Phillips screwdriver and remove
the tension adjuster;
IMPORTANT! When initially assembled, a “threadlocker” was
inserted on the screw thread to prevent it from accidentally
working loose; this means that a certain amount of force will
be needed to remove the screw. Use a clamp to block the bar
in place and always use a suitable sized screwdriver.
• reassemble the tension adjuster on the other side of the
overturned bar, or on the new bar;
• apply a small amount of “threadlocker” on two or three
screw threads (following the instructions provided by the
manufacturer), then tighten the screw as far as possible;
• replace the bar, the chain, and the casing, following the
assembly instructions in the “Bar and Chain Mounting”
section.
Chain Sprocket
Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 25).
Do not mount a new chain with a worn sprocket or vice-versa.
Fig. 23
Fig. 24
Screw
Tension
adjuster
< 0.5 mm
Fig. 25