Use and Care Manual

2. Next, release the quick-lock wheel for the lower handle by

turning it counterclockwise. This will allow you to move

the handle to the required position. Secure the handle by

turning the wheel in the opposite direction (Fig. 2).

Fitting the Grass Bag

IMPORTANT! Before tting the grass bag, ensure that the

safety key has been pulled, the motor is switched o, and the

blade has come to a complete standstill.

1. Clip the protective plastic straps onto the support rod

(Fig. 3).

2. Lift the ejector ap with one hand.

3. With the other hand, hold the grass bag by the handle and

hook it in from above (Fig. 4).

Setting the Cutting Height

IMPORTANT! Before adjusting the cutting height, make sure

the motor is switched o and the safety key has been pulled.

1. To set the cutting height on your lawn mower, pull out

the cutting height adjustment lever, move the lever to the

left or right, and push it back into one of the six cutting

positions indicated below. Make sure that the lever

engages properly (Fig. 5).

6-Position Height Adjustment:

1. 1.18 in. (30 mm) 4. 2.17 in. (55 mm)

2. 1.38 in. (35 mm) 5. 2.60 in. (66 mm)

3. 1.77 in. (45 mm) 6. 3.15 in. (80 mm)

Before you begin to mow, check to ensure that the blade is not

blunt and that none of the fasteners are damaged. To prevent

any imbalance, replace blunt and/or damaged blades. To carry

out this check, rst switch o the motor and pull out the safety

key.

Fig. 2

Quick-lock wheel

Fig. 3

Protective

plastic straps

Support rod

Fig. 4

Ejectorap

Grass bag

Fig. 5

Cutting height

adjustment lever