Use and Care Manual

12
2. Pull the push lock button on the battery to pull the battery
pack up and out of the equipment (Fig. 9).
3. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the top green light will illuminate and
stay green (Fig. 10).
4. Place the battery pack into the charger by sliding the
pack as shown to lock it into position. When you insert
the battery into the charger, the bottom red light will
illuminate to indicate that the battery is charging (Fig. 11).
5. When the bottom light turns green, the battery is fully
charged (Fig. 11).
NOTE: An alternately ashing red and green light indicates a
temperature abnormality (i.e. that the battery pack is either
too hot or too cold). If there is only a red blinking light, this
indicates that something is wrong with the battery. Contact
Snow Joe
®
+ Sun Joe
®
customer service at 1-866-SNOWJOE
(1-866-766-9563).
Fig. 8
Locking
button
Battery
cover
Fig. 9
Push lock button
Fig. 10
green
Power on
Fig. 11
green
green
Fully charged
green
red
Charging