Use and Care Manual

11
2. The accessories can be connected with the unit as
indicated below (Fig. 12).
3. To connect the auto tire chuck or air blow gun to the air
hose, simply pull back the coupler on the air hose, and
insert the selected accessory. Release the coupler to lock
the accessory (Fig. 13).
4. To connect the ination needle/metal connection/rubber
connection to the air blow gun, simply screw them on
clockwise. Use the wrench provided for a secure and tight
connection (Fig. 14).
5. The air compressor is ready to use.
Using the Air Compressor
1. Turn the pressure regulator knob to adjust the output air
pressure to match the working pressure you need. You
can check the output pressure on the output pressure
gauge (Fig. 15).
NOTE: When adjusting the output pressure, turn the
knob clockwise to pass the desired setting, and then turn
counterclockwise to reach the desired pressure. DO NOT
exceed safety working pressure of the product that is
being inated.
NOTE: The output air pressure cannot be set higher than
the tank pressure.
2. If the air blow gun is attached, press down on the air blow
gun switch to release the air (Fig. 16).
Accessory Usage
Teon tape
Use to wrap every screw-
on thread to ensure a
proper seal
Metal connection
Connected with the
air blow gun. Used for
cleaning dust.
Rubber connection
Connected with the air
blow gun. Used for cleaning
dust on delicate surfaces.
Rubber will prevent the
delicate surfaces from being
scratched.
Inatable needle
Connected with the air
blow gun. Used for Ination
for ball products. e.g.
basketball, football, etc.
Air blow gun
Connected to the air hose
and controls the air ow.
Auto tire chuck
Connected to the air hose
and used for ination of
vehicle tires, such as car,
motorcycle, ATV.
Fig. 12
Air hose
Auto tire chuck
Air blow gun
Metal connector
Rubber
connector
Ination needle
Fig. 13
Coupler
Fig. 14
Screw
Fig. 15
Regulator
knob
Output air
pressure gauge