Use and Care Manual

14
iCHRG40
Federal Communications Commission (FCC)
mWARNING! Any changes or modications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Class B device:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Troubleshooting
mWARNING! Always turn the tool OFF and remove the battery before performing any adjustments, maintenance, or
repairs to your cordless blower vac.
Unit will not
blow or mulch
Unit will not start
1. Bag full.
2. Blocked tube.
3. Blocked impeller.
4. Dirty bag.
5. Torn bag.
6. Bag unzipped.
7. Battery loose/not properly secured.
1. Battery loose/not properly secured.
2. Power switch is in the OFF (0) position.
3. Defective power switch.
4. Vac tubes are not correctly installed.
5. Inlet cover is not closed.
6. House circuit may have tripped.
1. Empty the bag.
2. Clear the blockage.
3. Clear the blockage.
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. Insert the battery until it clicks and lock into position.
1. Insert the battery until it clicks and
lock into position
2. Slide the power switch to the ON (1) position and
select your desired speed setting with the speed
control switch.
3. Call the Snow Joe
®
+ Sun Joe
®
customer service
center at 1-866-SNOWJOE (1-866-766-9563).
4. Check vac tubes and ensure that they are
correctly installed to allow the switch to be
engaged.
5. Ensure that Inlet cover is fully closed and locked.
6. Check wall circuit breaker panel and reset if
necessary.
Problem Possible Cause Solution