Use and Care Manual

ManualsBrandsSun Joe ManualsLawn Mowers14 in. 28-Volt Cordless Walk-Behind Push Mower Kit with 5.0 Ah Battery + Charger

Unpacking

Carton Contents

• Cordless lawn mower

• Grass collection bag

• Grass collection bag support rod

• Upper handle

• Upper handle knob and bolt assembly (2)

• Lower handle

• Lower handle screws (2)

• Spanner

• Screws (2)

• Cable clips (2)

• Battery charger

• Manual and registration card

1. Carefully remove the lawn mower and check to see that all

of the above items are supplied.

2. Inspect the product carefully to make sure no breakage

or damage occurred during shipping. If you nd damaged

or missing parts, DO NOT return the unit to the store.

Please call the Snow Joe

+ Sun Joe

customer service

department at 1-866-SNOWJOE (1-866-766-9563).

NOTE: Do not discard the shipping carton and packaging

material until you are ready to use your new cordless lawn

mower. The packaging is made of recyclable materials.

Properly dispose of these materials in accordance with

local regulations.

Assembly

mWARNING! Do not insert the safety key until assembly

is complete. Failure to comply could result in accidental

starting and serious personal injury.

mWARNING! Before performing any maintenance, make

sure the key is removed from the unit. Failure to heed this

warning could result in serious personal injury.

mWARNING! The product must be fully assembled

before operation. Do not use a product that is only partially

assembled or assembled with damaged parts.

NOTE: Before using the mower, follow these instructions to

assemble the handle and grass bag.

Handle Assembly

1. Fit the lower handle into the two holes in the machine

body and fasten the handle on both sides with the screws

provided (Fig. 1).

2. Join the upper handle to the lower handle using the knob,

plastic washer and bolt provided (Fig. 2). Repeat on the

opposite side.

Grass Collection Bag Assembly + Fitting

1. Fit the support rod into the holes in the plastic cover.

The bend of the support rod should face the rear of the

machine (Fig. 3).

Fig. 1

Machine body

Screw

Lower handle

Fig. 2

Upper handle

Plastic washer

Knob

Bolt

Fig. 3

Support rod

Plastic

cover