User Manual

ManualsBrandsSun Joe ManualsSun Joe WeatherproofingSnow Joe SJ615E Electric Single Stage Snow Thrower - 15-Inch - 11 Amp Motor

4. Use your right hand to press the belt with the ribbed side

down. While holding the belt down with your right hand,

use your left hand to turn the auger forward so that the

auger pulley rotates in a clockwise direction. The belt will

be gradually pushed down onto the pulley. When the belt

is seated on the pulley, adjust it so that the ribs of the belt

match the grooves on the pulley. (Fig. 35).

5. After the belt is installed, replace the side plate and secure

it with the 4 screws (Fig. 32).

NOTE: Heavy wet snow puts a load on belts, thus

requiring more frequent belt replacement.

Storage

1. Allow the engine to cool completely before cleaning,

storing, or transporting the snow thrower. Be

sure to secure the unit while transporting.

2. Disconnect the extension cord from the snow thrower.

Inspect the extension cord closely for signs of wear or

damage. Replace it if it is worn or damaged.

3. Inspect the snow thrower carefully for worn, loose, or

damaged parts. Check connections and screws and

tighten if necessary. For repairing or replacing parts,

contact your authorized Snow Joe

+ Sun Joe

dealer

or the Snow Joe

+ Sun Joe

customer service center at

1-866-SNOWJOE (1-866-766-9563).

4. Store the unit, along with the disconnected extension

cord, in a locked, dry place out of the reach of children to

prevent unauthorized use or damage. Cover loosely with a

tarp for added protection.

Service and Support

If your Snow Joe

SJ615E electric snow thrower requires

service or maintenance, please call the Snow Joe

+ Sun Joe

customer service center at 1-866-SNOWJOE

(1-866-766-9563).

Model and Serial Numbers

When contacting the company, reordering parts or arranging

service from an authorized dealer, you will need to provide the

model and serial numbers, which can be found on the decal on

the housing of the unit to the left of the discharge chute. Copy

these numbers into the space provided below.

Fig. 35

Record the following numbers from the housing or handle of your

new product:

Model #:

Serial #:

S J 6 1 5 E