User Manual

9
3. Turn the chute control crank clockwise to ensure the
discharge chute and deector are in position.
Operation
NOTE: Before using this machine, make sure that the power
source you will use complies with the specications detailed
in this manual. Before inserting the plug into the socket, verify
that the snow thrower’s auger and rubber plates are rmly
secured, and that the rubber plates are facing the correct
direction. Perform a test run to ensure that the rotor turns
freely.
Securing the Extension Cord
1. For safe and ecient use of your snow thrower, use only
a UL-rated extension cord recommended for outdoor use.
Refer to the Extension Cord Chart on page 2.
2. Push a loop of the extension cord through the slot on the
cord lock from the opposite side of the restraint hook.
Position the loop over the hook and pull the cable back
through the slot (Fig. 16).
3. Insert the female end of the extension cord into the
appliance's polarized male plug (Fig. 17).
4. Note that the snow thrower has a polarized male plug –
one prong in the plug is slightly longer and wider than the
other (Fig. 18). The extension cord female end should be
likewise polarized so that the extension cord ts snugly
into the appliance plug.
PoweringOnandO
mWARNING! The auger starts rotating immediately
after the snow thrower is switched on. Keep hands
and feet away from the auger.
1. To power on, depress and hold the safety switch button
found alongside the switch housing (Fig. 19).
2. While depressing the safety switch button, pull the
ON/OFF switch lever toward you. Once the machine
powers on, release the safety switch button and begin
operation (Fig. 19). The machine can only be started by
depressing the safety switch button rst, followed by
squeezing the ON/OFF switch lever; reverse operation will
not start the machine.
3. To power o, release your grip on the ON/OFF
switch lever.
Fig. 16
Extension
cord
Slot
Fig. 17
Fig. 18
m WARNING m
Damagedelectricalcordspresentriskofre,
electrical shock, and serious bodily injury.
Before operating the snow thrower, carefully examine
the electrical cord. If the cord is damaged, do not use
the snow thrower. Replace or repair the damaged
cord immediately. If you need assistance, contact an
authorized Snow Joe
®
+ Sun Joe
®
service center.
Fig. 19
Safety switch
button
ON/OFF
switch lever