Use and Care Manual
10
Adjusting the Telescoping Pole
1. Disconnect the pole hedge trimmer from the power supply.
2. Unclip the cam-lock to release the pole (Fig. 7).
3. Extend the pole to the desired length (Fig. 8).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the hedges to be trimmed.
4. Lock the pole in position by closing the cam-lock (Fig. 9),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
mWARNING! Extend the telescoping pole only to the
length required to reach the hedges being trimmed. Adjust
your hand placement on the telescoping pole of the pole
hedge trimmer in order to keep proper balance.
Do not attempt to use the pole hedge trimmer at a length
which does not allow you to achieve proper footing and
balance at all times!
mWARNING! Failure to lock the telescopic pole cam-lock
as directed could result in personal injury.
Tightening the Bolt
The retaining bolt may need tightening to secure the telescopic
pole in place.
1. Unclip the cam-lock. Using the hex key wrench, tighten
the cam-lock nut, then close the cam-lock. Ensure that the
pole is secure. The wrench may be required to loosen the
cam-lock nut if you need to adjust the pole to a dierent
height (Fig. 10).
Adjusting Pivoting Head
The pole hedge trimmer head can be rotated into 6 dierent
cutting angles.
1. Always disconnect the pole hedge trimmer from the
power supply.
2. Place the pole hedge trimmer on a sturdy at surface.
3. Press the pivot button and adjust the trimmer head to the
desired angle (Fig. 11).
Cam-lock
Fig. 7
Telescoping pole
Fig. 8
Cam-lock
Fig. 9
Cam-lock nut
Hex key wrench
Fig. 10
60º
30º
-30º
-60º
-90º
0º
Fig. 11
Pivot button