Use and Care Manual

10
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe
®
SWD2500 electric wet/dry vacuum, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
mWARNING! Disconnect the power cord before
performing any maintenance task.
If the power is still connected, the unit could be accidentally
turned on while you are performing maintenance on it, which
could result in personal injury.
Cleaning The Dust Tank
Clean the equipment routinely after each use:
1. Take the unit outside to clean it to avoid creating a mess
indoors.
2. Remove the power head and empty the dust tank. Clean
the tank with water and allow it to dry completely.
Cleaning the Cloth Filter
mWARNING! To avoid serious personal injury, always
turn the unit o and unplug it before cleaning or servicing.
The cloth lter included is made of high quality material
designed to stop small dust particles. The lter should be used
for dry pick-up only. If the dust lter is wet, it will clog quickly
and be very dicult to clean. Handle the lter carefully when
removing it for cleaning and replacing. Check the lters for
tears or small holes, a small hole can let dust pass through
and out of the cleaner. Do not use a lter with holes or tears,
replace it immediately.
1. Switch o and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, slide the lter locking ring up and remove it. Then
carefully remove the cloth lter from the lter cage
(Fig. 9).
4. Clean the cloth lter by gently tapping or brushing dirt o.
Cleaning should not be done indoors in living areas.
5. If needed, use a mild soap and water solution to wash the
cloth lter and rinse with clean water. Allow the wet lter
to air dry for 24 hours before installing onto the lter cage.
Cleaning the Foam Filter
mWARNING! The foam lter must be cleaned every time
after wet vacuuming.
1. Switch o and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, carefully remove the foam lter from the lter
cage (Fig. 10).
NOTE: The foam lter can be attached to the lter cage
securely. The lter locking ring is not needed when only
the foam lter is attached.
4. Use a mild soap and water solution to wash the foam lter
and rinse with clean water. Allow the wet lter to air dry for
24 hours before installing onto the lter cage.
5. To assemble the lters, rst t the foam lter on the lter
cage, then t the cloth lter over the outside of the foam
lter. Last, slide the lter locking ring down, and press
(Fig. 11).
Fig. 9
Cloth lter
Filter locking
ring
Fig. 10
Foam lter
Fig. 11
Cloth lter
Filter locking
ring
Foam lter