Replacement Part List

ManualsBrandsSun Joe ManualsOutdoorsTiller Joe Max 9-Amp Electric Tiller and Cultivator

A Division of Snow Joe, LLC

Model No. TJ601E

Electric Tiller/Cultivator

Form No. TJ601E-880E

OPERATOR’S MANUAL

SAVE THESE INSTRUCTIONS

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Always follow these safety guidelines. Failure to do so may

result in serious bodily injury or death.

General Safety WARNINGS!

When using the electric tiller, basic safety precautions should

always be followed to reduce the risk of re, electric shock,

and personal injury, including the following:

m WARNING: When servicing use only identical replacement.

Polarized Appliance Connections to reduce the risk of electric

shock, this appliance has a polarized plug (one blade is wider

than the other) and will require the use of a polarized extension

cord. The appliance plug will t into a polarized extension cord

only one way. If the plug does not t fully into the extension

cord, reverse the plug. If the plug still does not t, obtain a

correct polarized extension cord. A polarized extension cord

will require the use of a polarized wall outlet. This plug will t

into the polarized wall outlet only one way. If the plug does

not t fully into the wall outlet, reverse the plug. If the plug still

does not t, contact a qualied electrician to install the proper

wall outlet. Do not change the equipment plug, extension cord

receptacle, or extension cord plug in any way. Before using

the tiller, take the time to familiarize yourself with the controls,

especially how to stop the tiller in an emergency. Only allow

responsible individuals who have a thorough understanding of

these instructions to operate the tiller. Never allow children to

operate the tiller. Retain this manual for future reference and

reread it at the start of each tilling session.

This symbol indicates important safety instructions. Failure

to observe and follow these instructions may result in personal

injury or property damage. Read and follow all instructions in

this manual before attempting to operate this machine.

TRAINING

1. Read, understand and follow all instructions on the tiller

and in the manual (s) before attempting to assemble and

operate. Save this manual for reference and ordering

replacement parts.

2. Never allow children under 16 years old to operate this

machine. Children 16 years old and over should be trained

and supervised by an adult who understands the operation

of the tiller.

3. Never allow an untrained individual to operate the tiller.

4. Understand the function of all the controls and their proper

operation. Know how to stop the machine and disengage

them quickly.

5. Always plan your tilling pattern to avoid discharge of

material toward people, pets and property. Thrown objects

can cause serious personal injury.

6. Keep people, pets and property at least 25 feet from the

tiller while it is in operation. Stop the tiller if people or pets

enter the discharge area.

7. Always observe the surface conditions in order to avoid

slipping, falling and unexpected objects.

PREPARATION

1. Always inspect the area where the tiller is to be used.

Remove all objects (e.g., stones, sticks, wires and foreign

objects) that could be thrown by the tines or cause the

operator to trip.

2. Thrown objects can cause serious injury to the eyes and

exposed body. Always wear safety glasses or eye shields

during operation and while performing an adjustment or

repair.

3. Always operate wearing adequate garments. Do not wear

jewelry or other loose clothing, which could become

entangled in moving parts. Wear footwear that provides

sure footing.

4. Observe any noise-prevention regulations and laws.

5. Inspect the tiller for worn, missing or damaged parts

and safety labels. See maintenance section for detailed

instructions.

ELECTRICAL SAFETY

1. Always use a grounded three-wire extension cord and

receptacle that is made of rubber and intended for

outdoor use.

2. Keep the extension cord away from the moving tines

and hot motor housing.

3. Avoid contact with metal objects.

Grounding

Metal Screw

Cover of Grounded

Outlet Box

Adapter

Grounding

Means

Grounding

Grounding method

AA210

(A)

(B)

(C)

(D)

Summary of content (10 pages)

PAGE 1
Electric Tiller/Cultivator Model No. TJ601E Form No. TJ601E-880E OPERATOR’S MANUAL A Division of Snow Joe, LLC Safety Instructions 5. Always plan your tilling pattern to avoid discharge of material toward people, pets and property. Thrown objects can cause serious personal injury. All Operators Must Read These Instructions Before Use 6. Keep people, pets and property at least 25 feet from the tiller while it is in operation. Stop the tiller if people or pets enter the discharge area.
PAGE 2
0. Use Right Appliance – Do not use appliance for any job except that for which it is intended. GENERAL OPERATION 1. Do not operate the machine while under the influence of alcohol or drugs. 21. Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) to be used for the gardening appliance. Receptacles are available having builtin GFCI protection and may be used for this measure of safety. 2. Keep all safety devices in place and working.
PAGE 3
3. Check Damaged Parts – Before further use of the appliance, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this manual.
PAGE 4
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand and follow all instructions in the manual(s) before attempting to assemble and operate. WARNING! Keep out of rain and away from wet areas. DANGER! Rotating objects may spin off and cause personal injury.
PAGE 5
Know Your Electric Tiller/Cultivator Part List Legend B A. Left Handle Grip/Grab handle B. Safety Button C A C. Right Handle Grip/Control Handle D. Power Switch D E. cable tesion relief F. Plastic Crossplate E G. Cable Guide F H. Upper Frame G I . Cable Clip J . Lower Frame K. Tines L. Driveshaft M. Wheels N. Motor Housing P H I O. Wing Nuts and Bolts P.
PAGE 6
Unpacking and using for the first time • (Fig. 1) Insert the control handle (C) and the grab handle (A) into the holes of the cross plate (F). Make sure that the control handle is on the side of the cable holder guide of the cross plate. Unpacking • Insert the screw bolts in the holes at the back of the cross plate, and tighten them. Ensure the handles are tightened in the cross plate. Unpacking the product and checking for completeness. See also: Disposing of packaging – Page 7.
PAGE 7
Operation Figure 3 Note: Before using this machine, make sure that the power source you will use complies with the specifications detailed in this manual. This machine is intended for breaking up and tilling coarse soil for the purpose of mixing in fertilizer, peat and compost in domestic areas. Any use other than that specifically named in this manual may lead to damage to the tool and represents a serious injury hazard for the operator.
PAGE 8
Note: The tines will begin to rotate and dig themselves into the ground. m WARNING m 2. After completing the work release Power Switch (D) (See Fig. 6) to turn the machine OFF. Damaged electrical cords present risk of fire, electrical shock, and serious bodily injury. Before operating the electric tiller, carefully examine the electrical cord. If the cord is damaged, do not use the electric tiller. Replace or repair the damaged cord immediately.
PAGE 9
Important! 1. Place the electric tiller on the ground. The rating label should be facing upward. • Wear protective gloves when cleaning or maintaining the machine. 2. Unscrew the hex bolt (T) (See Fig. 7) and the self-locking (U) (See Fig. 7). • Do not use cleaning fluids or solvents or spray the machine down with water (especially water under pressure) when cleaning the machine. 3. Remove the tine wheels off the driveshaft (L) (See Fig. 7). 4. Clean the driveshaft (L) with biodegradable oil. 5.
PAGE 10
A Two-Year Full Warranty for residential use in the United States and Canada General Conditions: Snow Joe, LLC warrants this product to the original purchaser for two years against defects in material or workmanship when used for normal residential purposes. Snow Joe, LLC will repair any defect in material or workmanship, and repair or replace any defective part, subject to the conditions, limitations, and exclusions set forth herein.