Use and Care Manual
8
2. Place the spool cover on the spring and press it rmly
down until the locking devices of the spool cover securely
click into place (Fig. 15).
Check length of nylon cutting line
1. Pull line to inner edge of outer safety guard. If the line is
too short, i.e., more than 50 mm from inside edge of safety
guard, push down on centre of trimmer head and at the
same time pull the line a few centimeters past the edge of
the safety guard (Fig. 16).
To increase line length
NOTE: The grass trimmer comes with a full line spool. The line
wears down during work. To feed in new line:
1. Switch the machine on and press the head of the spool
rmly against the ground.
2. The line will automatically be released by centrifugal force.
The trimmer line will be cut to the right length by the blade
on the spool cover.
Operation
The Electric Grass Trimmer/Edger is intended for the cutting
of grass and weeds under bushes, as well as on slopes
and edges that cannot be reached with the lawn mower.
The trimmer must be used outdoors only, at an ambient
temperature between 0ºC and 45ºC.
mWARNING! Remove stones, loose pieces of wood
and other objects from the cutting area. The blade continues
to rotate for a few seconds after the trimmer is switched off.
Allow the motor to stop rotating before switching on again. Do
not rapidly switch off and on.
ON/OFF switch
1. To switch the grass trimmer ON, press and hold the safety
button, then squeeze the ON/OFF trigger and you can now
release the safety button.
2. To switch OFF, release the ON/OFF trigger.
Cutting grass
1. Move the grass trimmer left and right, keeping it well away
from the body. The trimmer can efciently cut grass up to
a height of 15 cm. Cut higher grass in stages.
2. When using the trimmer hold at an angle of about 20° to
the ground (Fig. 17) and swing the trimmer from side to
side (Fig. 18).
Fig. 15
Locking
Devices
Spool
Spool Cover
Fig. 16
Spool
Outer Guard
Centre of Trimmer Head
20°
Fig. 17
Fig. 18