Use and Care Manual
6
2. Trimming
a) Use the trimmer at an angle of approximately 15-degrees
to the working area (Fig. 6).
b) Slowly swing the trimmer from side to side (Fig. 7).
3) Do not overload your trimmer, take small “bites”. This will
keep machine operating at high speed and will greatly
improve cutting efciency (Fig. 8).
3. Starting for the rst time and operation
You will need to exert a certain force to pull out the line when
the trimmer is used for the rst time. To do so, press on the
15°
Fig. 5
Fig. 6
Fig. 7
Fig. 8