Use and Care Manual

7
push button (Fig. 9) and pull out the line as far as the edge of
the guard hood.
The line will be cut to the correct length the rst time the
cutting head is started. A short worn nylon line will result
in poor cutting performance.
To restore the correct line length, press the trimmer against
the ground while the cutting head is running.
The length of the line will then be adjusted automatically
(Fig. 10).
4. To replace the spool or cutting line
m WARNING: Unplug the mains supply
cable before attempting to change the line.
a) Hold the fan housing (1) and screw the spool cover (3)
anticlockwise until it can be removed (Fig. 11).
b) Replace the empty line spool with a full one. Thread the
end of the line through the holes inside of the spool
cover (3).
c) Place the spool cover on the fan, hold the fan housing
and, screw the spool cover clockwise until it sits
securely.
d) Press on the push button and pull out line as far as the
edge of the guard hood.
e) The line will be cut to the correct length the rst time
the cutting head is started.
m CAUTION! Catapulted pieces of nylon line may
cause injury.
Note: The maximum recommended length of line in the spool
is 10-FT (3m) per slot.
3
2
1
Fig. 9
Fig. 11
Fig. 10
Fan Housing
Spool
Spool Cover