Use and Care Manual

8
m WARNING: Pay attention to winding direction.
a) Always replace the spool with a new pre-wound spool.
b) Insert the end of the line through an eyelet in the
cutting head.
IMPORTANT: Keep all areas of the cutting head cover and
cutting head clean. Place the cap back by pushing it rmly
into the cutting head. To ensure that the cutting head cover
is correctly tted, try to remove it without depressing the two
latches. If it is correctly tted it should not move.
Maintenance
Be sure the tool is unplugged.
1) Your grass trimmer requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool.
2) Your trimmer line can dry out over time. To keep your line
in top condition, store spare pre-wound spools or bulk line
in plastic, sealable bag with a tablespoon of water.
3) Never use water or chemical cleaners to clean your grass
trimmer. Wipe clean with a dry cloth.
4) Plastic parts may be cleaned by using a mild soap and
damp rag.
5) Always store your grass trimmer in a dry place. Do not
allow any liquid to get inside it.
6) Keep the motor ventilation slots clean.
7) If you see some sparks ashing in the ventilation slots, this
is normal and will not damage your power tool.
8) There are no user serviceable parts in the trimmer. If a
fault is suspected return the trimmer to an authorized
dealer for repair.
IMPORTANT:
To assure product safety and reliability, repairs, maintenance
and adjustment should be performed by authorized service
centers or other qualied service organization, always using
identical replacement parts.
Troubleshooting
If your tool seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local dealer’s Authorised Service Centre.
• Before proceeding, unplug the tool.
Tool runs slowly
• Check that the spool housing can rotate freely. Carefully
clean it if necessary.
• Check that the cutting line does not protrude. If it does,
cut it off so that it just reaches the line trimming blade.
Bump line feed does not work
• Keep the tabs depressed and remove the spool cover
from the housing.
• Pull the cutting line until it reaches the trimming blade.
If insufcient cutting line is left on the spool, install a
new spool of cutting line as instructed above.
• Align the tabs on the spool cover with the holes in
the housing.
• Push the cover onto the housing until it snaps securely
into place.
• If the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
Service and Support
If your Electric Grass Trimmer requires service or maintenance,
please call 1-866-766-9563 for assistance.
Model and Serial Numbers
When contacting the company or reordering parts, you will
need to provide the model and serial numbers of your product.
These are found on the decal afxed to the housing or guard
of your Electric Grass Trimmer. Copy these numbers into the
space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
Serial #:
T R J 6 0 9 E