Fast Ethernet Adapter Product Note

2 SunFastEthernetAdapter—July1994
which automatically installs the driver SUNWbmac. For the “Entire
Distribution”, “Programmer” and ”End User Support” clusters, the driver is
installed only if SunFastEthernet Adapter hardware is installed in the system.
If SunFastEthernet hardware was not installed when the Solaris 2.3 Hardware:
8/94 software distribution was installed using one of the last four clusters,
then the driver is not automatically installed via suninstall, instead, the driver
must be installed using the pkgadd command. Refer to “Adding SUNWbmac
using Pkgadd Command”, page 5, in the SunFastEthernet User Guide, P/N
801-6109-10.
Net-InstallServers(Solaris2.3Hardware:5/94Only)
Note – The Solaris CD cannot be used to do a net-install (read only), thus the
following section is applicable only when the Solaris CD image is archived to a
disk.
To allow net-install over the be interface the be minor-device- number must be
added to your particular architecture’s name_to_major file. To determine the be
minor-device-number proceed as follows:
1. Determine the directory where the Solaris CD image is loaded.
For example, if the Solaris software is located within a directory named DIR,
then type the following:
Table 1 Solaris 2.3 Hardware: 8/94 CD
Cluster Size
Entire Distribution plus OEM Support 298.80 MByte
Entire Distribution 298.1 MByte
Programmer 220Mbyte
End User System Support 125.37 MByte
Core System Support 59.88 MByte
# cd DIR/export/exec/kvm