Computer Accessories User Manual

Chapter 6 Using Windows 2000 Professional or Windows 2000 Server 67
13. Click OK to close the System Properties dialog box.
To enable the physical adapter to use TCP/IP in the network, you need to complete
the procedure “How to Configure the Network for Windows 2000” on page 65.
▼ How to Prepare Windows 2000 to Display
External Video
To use an external monitor, you need to attach the monitor to the SunPCi III main
card backplate and install the external video driver. The video drivers are now
automatically installed during the SunPCi III installation.
Caution – Do not use both system and external monitors at the same time. SunPCi
software does not support multi-headed operation.
To complete this configuration, perform the following procedures:
1. Attach the monitor to the external video port connector on the SunPCi III main
card backplate.
Refer to FIGURE 10-1 to find the location of the external video port.
2. Close Windows 2000 and the SunPCi III software.
3. At the Solaris system prompt, restart the SunPCi III software using the -v option:
Note – If you do not use the -v option, the Sun display will appear scrambled.
The SunPCi III software starts, and Windows 2000 opens first on the external
monitor, and then on your system monitor in the SunPCi III window.
4. Attach the mouse by pressing Meta-M.
You are now ready to configure the Windows 2000 display as described in the
following procedure.
% /opt/SUNWspci3/bin/sunpci -v