Computer Accessories User Manual

146 SunPCi III 3.2.1 User’s Guide • March 2004
Missing Master.ini File After Factory
Installation
If you have SunPCi III 3.2.1 software preinstalled or if you install the SunPCi III 3.2.1
software before the hardware, the/etc/Master.ini file will not get created and
you will receive the following message when attempting to first open SunPCi III:
To run SunPCi III 3.2.1 software properly, you must force the reloading of the
SunPCi Solaris driver, as well as the creation of the /etc/Master.ini file by doing
the following:
1. Go to the /opt/SUNWspci3/drivers/solaris directory in SunPCi III 3.2.1
software.
2. Type the sunpcload command.
Note – You must be superuser for the sunpcload command to work properly.
This command reloads the Solaris driver for SunPCi III 3.2.1 software and creates the
/etc/Master.ini file, which contains the configuration information needed to
properly run SunPCi III 3.2.1 software.
Sun Blade Workstation and Sun Enterprise Server
Software Issue
If you have a SunPCi III card preinstalled in a Sun Blade™ workstation or a
Sun Enterprise™ server or if the software version is not SunPCi III 3.2.1, you might
need to install the SunPCi III 3.2.1 software after you configure your preinstalled
Solaris image.
● To verify whether your SunPCi III software is already installed, type the
following command at the system prompt:
ERROR, there are no cards specified in the Master.ini file.
% pkginfo -l SUNWspci3