User Guide

Chapter 4 Replacing Cold-Swappable Components 4-23
2. Enter the Open Boot Prompt (OBP) and use the show-disks command to list
the current devices.
In the following example, the HBA is the first device that is listed.
Note – Device paths might vary from this example, depending on which SPARC
system you are using and into which PCI-E slot the card is plugged.
3. Use the select command to select the device node for the HBA, and follow
the on-screen instructions by pressing Enter when prompted.
Note – When you run this command, omit /disk from the HBA device path, as
shown in the following example.
{0} ok show-disks
a) /pci@500/pci@0/pci@9/scsi@0/disk
b) /pci@500/pci@0/pci@2/pci@0/usb@0,2/storage@5/disk
c) /pci@500/pci@0/pci@2/pci@0/usb@0,2/storage@1/disk
{0} ok select /pci@500/pci@0/pci@9/scsi@0
Waiting for AAC Controller to start: . . Started