Server User Manual
Table Of Contents
- Sun Netra™ CP3250 Blade Server User’s Guide
- Contents
- Figures
- Tables
- Preface
- Overview
- Hardware Installation and Service
- 2.1 Safety and Tool Requirements
- 2.2 Installing the Blade Server
- 2.3 Service Procedures
- 2.3.1 Hot-Swapping the Netra CP3250 Blade Server
- 2.3.2 Powering Off the Netra CP3250 Blade Server
- 2.3.3 Removing the Netra CP3250 Blade Server
- 2.3.4 Powering On the System
- 2.3.5 Automatic Power-Off Events
- 2.3.6 Servicing DIMMs
- 2.3.7 Installing the Optional Compact Flash Card
- 2.3.8 Installing Optional AMC
- 2.3.9 Adding or Replacing the Battery
- 2.3.10 Changing Jumper Settings
- 2.3.11 Checking DIP Switch Settings
- 2.3.12 Resetting the Netra CP3250 Blade Server
- Hardware Architecture
- Software Configuration
- Configuring and Using BIOS Firmware
- 5.1 About BIOS Settings
- 5.2 Changing the Configuration of a BIOS Menu Item
- 5.3 Setting the Boot Device Using BIOS Setup Screens
- 5.4 Setting Supervisor and User Passwords
- 5.5 Resetting the System Time and System Date
- 5.6 Updating the BIOS
- 5.7 Secondary BIOS Image
- 5.8 Perform a Live Firmware Upgrade
- 5.9 Power-On Self-Test
- 5.10 Changing POST Options
- BIOS Screens
- Physical Characteristics
- ShMM CLI and Commands
- Index
iii
Contents
Preface xiii
1. Overview 1–1
1.1 Overview 1–2
1.2 Features 1–2
1.3 Physical Description 1–4
1.3.1 Front Panel Components 1–4
1.3.2 Blade Server Diagram 1–6
1.4 System Configurations 1–7
1.4.1 AMC 1–8
1.4.2 Advanced Rear Transition Module 1–8
1.5 Hot-Swap Support 1–11
1.6 System Components 1–11
1.6.1 Required Hardware Components 1–11
1.6.2 Optional Hardware Components 1–12
1.6.3 Software Components 1–12
1.7 Technical Support and Warranty 1–13
1.7.1 Locating the Part Number and Serial Number Information 1–13
1.7.2 Viewing the Electronic Blade Server ID Information 1–14