Server User Manual
Table Of Contents
- Sun Netra™ CP3250 Blade Server User’s Guide
- Contents
- Figures
- Tables
- Preface
- Overview
- Hardware Installation and Service
- 2.1 Safety and Tool Requirements
- 2.2 Installing the Blade Server
- 2.3 Service Procedures
- 2.3.1 Hot-Swapping the Netra CP3250 Blade Server
- 2.3.2 Powering Off the Netra CP3250 Blade Server
- 2.3.3 Removing the Netra CP3250 Blade Server
- 2.3.4 Powering On the System
- 2.3.5 Automatic Power-Off Events
- 2.3.6 Servicing DIMMs
- 2.3.7 Installing the Optional Compact Flash Card
- 2.3.8 Installing Optional AMC
- 2.3.9 Adding or Replacing the Battery
- 2.3.10 Changing Jumper Settings
- 2.3.11 Checking DIP Switch Settings
- 2.3.12 Resetting the Netra CP3250 Blade Server
- Hardware Architecture
- Software Configuration
- Configuring and Using BIOS Firmware
- 5.1 About BIOS Settings
- 5.2 Changing the Configuration of a BIOS Menu Item
- 5.3 Setting the Boot Device Using BIOS Setup Screens
- 5.4 Setting Supervisor and User Passwords
- 5.5 Resetting the System Time and System Date
- 5.6 Updating the BIOS
- 5.7 Secondary BIOS Image
- 5.8 Perform a Live Firmware Upgrade
- 5.9 Power-On Self-Test
- 5.10 Changing POST Options
- BIOS Screens
- Physical Characteristics
- ShMM CLI and Commands
- Index
Chapter 2 Hardware Installation and Service 2-19
2.3.6 Servicing DIMMs
2.3.6.1 DIMM Requirements
The Sun Netra CP3250 blade server supports a total of six DIMMs and the maximum
memory capacity of 24 GB (using four 4 GB DIMMs). The Sun Netra CP3250 blade
server accommodates the following DIMMs and configurations:
■ Up to six standard DDR2 SDRAM registered/ECC DIMMs
■ DIMMs must be installed in matching pairs
■ 2 GB and 4 GB DDR2 modules are supported
■ Maximum of 24 GB in six slots
The Sun Netra CP3250 blade server supports DIMMs that have the following
characteristics:
■ A 144-bit wide data bus DDR2 interface (2x64-bit data + 2x8-bit ECC)
■ DDR2 DIMM: 4.4 - 7.0 watts (1.8 V)
■ Very low profile (VLP) with a maximum height of 0.72 inch (18.3 mm)