Computer Accessories User Manual

INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK
10 VTL Value Hardware Installation Guide • Aug 2007 A • 316196101
5. If the rack has threaded mounting holes in the rack posts, insert the correct, metric or
standard mounting screws through the slide-rail brackets and into the threaded holes.
The Sun™ Rack 1000 hardware uses metric screws.
6. If your rack does not have threaded mounting holes, insert the mounting screws
through both the slide-rail brackets and rack posts, and then secure them with caged
nuts.
7. Hand-tighten the screws in the front bracket holes (
K below).
You will use a slide-rail spacing tool later to make final adjustments.
8. Repeat this procedure with the remaining, unsecured middle/outer rail.
Next task: “A dj u st in g  andse c urin gmiddle/outersliderails”onpage 11.
K