Computer Accessories User Manual
INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK
316196101 • A Chapter 1 Installing VTL Value hardware 13
6. Once both slide rails are loosely fastened at the rear, insert the slide-rail spacing tool
into the outer rail brackets (
D below).
7. Hold the spacing tool in place (
E above) as you tighten all four rear screws with a #2
Phillips screwdriver (F).
The spacing tool should be a snug fit and might require pressure to ensure that it is fully
engaged with the left and right slide rails.
8. Pull the slide-rail spacing tool straight out from the slide rails, taking care not to
deform its alignment tabs.
Next task: “Mountingtheapplianceintherack”onpage 13.
Mounting the appliance in the rack
Once the inner rails are attached to the appliance chassis and the outer/middle rail assemblies
are attached to the rack, you are ready to install the appliance in the rack. Proceed as follows.
D
E
F