Computer Accessories User Manual

REMOVING THE CABLE MANAGEMENT ARM

50 VTL Value Hardware Installation Guide • Aug 2007 A • 316196101

Removing the cable management arm

If you need to access the system controller (SC), remove the cable management arm (CMA)

using the following procedure.

1. If you have not already done so, shutdown main (server) and standby (service

processor) power, as described in “Shutting off system power” on page 49.

2. Unplug the power and data cables from the server.

3. Lift the small tab (

A below) on the CMA-to-chassis bracket to release the right pinhead

(

B).

4. Push the CMA toward the chassis (

C above), so that the second pinhead (D) aligns with

the keyhole (

E), freeing the CMA to drop away from the bracket.

5. Pull the CMA away from the rear of the chassis, and remove the CMA from the

slide-rail extension.