Ethernet MMF/UTP Adapter Installation and User's Guide

Appendix B Diagnostic Software 75
Note – To test all of the interfaces of the adapter, you need to execute the test
command separately for each SUNW,ipge interface.
If all of the tests pass, you will see these messages:
If the adapter being tested is the Sun PCI-Express Dual Gigabit Ethernet MMF
adapter and the external loopback cable is not connected, you will see the following
error message:
8. After testing the adapter, type the following commands to return the OpenBoot
PROM to the standard operating mode.
ok test /pci@780/pci@0/pci@8/network@0,1
Testing /pci@780/pci@0/pci@8/network@0,1
Interrupt registers test PASSED.
Receive registers test PASSED.
Transmit registers test PASSED.
Wakeup registers test PASSED.
PCI-E registers test PASSED.
Diagnostic registers test PASSED.
Loopback test (1000Mbps, full duplex) PASSED
1000 Mbps full duplex Link up
ok
ok test /pci@7c0/pci@0/pci@9/network@0,1
Testing /pci@7c0/pci@0/pci@9/network@0,1
Interrupt registers test PASSED.
Receive registers test PASSED.
Transmit registers test PASSED.
Wakeup registers test PASSED.
PCI-E registers test PASSED.
Diagnostic registers test PASSED.
Loopback test (1000Mbps, full duplex) Internal loopback packet RX
failed
Check if an external loop is plugged then try again.
Exiting further tests
ok
ok setenv diag-switch? false