Ethernet MMF/UTP Adapter Installation and User's Guide

18 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
Rebooting the System
After verifying the adapter installation, use the boot -r command to perform a
reconfiguration boot on your system.
The reconfiguration boot attaches the driver to the adapter. You can now configure
the driver parameters for your Sun PCI-Express Dual Gigabit Ethernet adapter.
Installing the ExpressModule Adapter
The following instructions describe the basic tasks required to install the adapter.
Refer to your system installation or service manual for detailed ExpressModule
adapter installation instructions.
This section contains the following topics:
■ “To Install the ExpressModule Adapter Using Hot-Plug” on page 18
■ “To Verify the ExpressModule Installation” on page 19
▼ To Install the ExpressModule Adapter With
Power Off
1. Open the latch.
2. Insert the module.
3. Close the latch.
▼ To Install the ExpressModule Adapter Using
Hot-Plug
1. Insert the ExpressModule for the system blade into its corresponding slot.
2. Close the latch.
ok boot -r