Ethernet MMF/UTP Adapter Installation and User's Guide

Chapter 3 Configuring ipge and e1000 Driver Parameters 29
If the link partner is not capable of autonegotiation (when lp_autoneg_cap is 0),
the remaining information described in
TABLE 3-1 is not relevant and the parameter
value = 0.
If the link partner is capable of autonegotiation (when lp_autoneg_cap is 1), then
the speed and mode information is displayed when you use autonegotiation and the
link partner capabilities.
lp_cap_100hdx 0 = No 100 Mbit/sec half-duplex transmission
1 = 1000 Mbit/sec half-duplex
lp_cap_10fdx 0 = No 10 Mbit/sec full-duplex transmission
1 = 10 Mbit/sec full-duplex
lp_cap_10hdx 0 = No 10 Mbit/sec half-duplex transmission
1 = 10 Mbit/sec half-duplex
lp_cap_asm_pause 0 = Not asymmetric pause capable
1 = Asymmetric pause towards link partner capability
lp_cap_pause 0 = Not symmetric pause capable
1 = Symmetric pause capable
TABLE 3-1 Read-Only Link Partner Capabilities (Continued)
Parameter Description