Ethernet MMF/UTP Adapter Installation and User's Guide

36 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
Operational Mode Parameters
The parameters in TABLE 3-5 determine the transmit and receive speed and duplexing
capability.
TABLE 3-5 also describes the operational mode parameters and their
default values.
Note – If a parameter’s initial setting is 0, it cannot be changed. If you try to change
the setting, it will revert back to 0.
TABLE 3-5 Operational Mode Parameters
Parameter Description
adv-autoneg-cap Local interface capability advertised by the hardware
0 = Forced mode
1 = Autonegotiation (default)
adv-1000fdx-cap Local interface capability advertised by the hardware
0 = Not 1000 Mbit/sec full-duplex capable
1 = 1000 Mbit/sec full-duplex capable (default)
adv-1000hdx-cap Local interface capability advertised by the hardware
0 = Not 1000 Mbit/sec half-duplex capable
1 = 1000 Mbit/sec half-duplex capable (default)
adv-100T4-cap Local interface capability advertised by the hardware
0 = Not 100T4 capable (default)
1 = 100T4 capable
adv-100fdx-cap Local interface capability advertised by the hardware
0 = Not 100 Mbit/sec full-duplex capable
1 = 100 Mbit/sec full-duplex capable (default)
adv-100hdx-cap Local interface capability advertised by the hardware
0 = Not 100 Mbit/sec half-duplex capable
1 = 100 Mbit/sec half-duplex capable (default)
adv-10fdx-cap Local interface capability advertised by the hardware
0 = Not 10 Mbit/sec full-duplex capable
1 = 10 Mbit/sec full-duplex capable (default)
adv-10hdx-cap Local interface capability advertised by the hardware
0 = Not 10 Mbit/sec half-duplex capable
1 = 10 Mbit/sec half-duplex capable (default)