- Sun Installation and User's Guide GigaSwift Ethernet Adapter

98 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • August 2004
8. After testing the adapter, type the following commands to return the OpenBoot
PROM to the standard operating mode.
9. At the ok prompt, reset the auto-boot? configuration variable to true.
10. Reset and reboot the system.
Refer to the system’s documentation for the correct procedures for bringing up the
system.
Troubleshooting Issues
Known Incompatibilities With Pre-IEEE 802.3z
Network Switches
You might experience interoperability issues when using the Sun
GigaSwift Ethernet adapter with the SunSwitch switch, the Alteon ACE 110 switch,
or other pre- or non-IEEE 802.3z standard compliant network equipment. If you
experience difficulties with noncompliant equipment, set the adapter and switch
autonegotiation properties to off and try to configure the interface manually.
▼ To Set Autonegotiation to off for a SunSwitch
or an Alteon ACE 110 Switch
You can set autonegotiation to off for SunSwitch and Alteon ACE 110 switches
using those switches’ configuration program (cgf). Refer to your switch
documentation for instructions on how to access and use the cgf program.
ok setenv diag-switch? false
ok setenv auto-boot? true
ok reset-all