- Sun Installation and User's Guide GigaSwift Ethernet Adapter

Appendix D Diagnostic Software and Troubleshooting Issues 99
The following procedure describes how to turn autonegotiation off for one
SunSwitch port.
1. Establish a connection to the switch using either a serial connection or a Telnet
connection.
Refer to the SunSwitch 1.1 Installation and Configuration Guide (805-3743-10) for more
information. After connecting to the switch, the Main menu prompt (Main#)is
displayed.
2. At the Main# prompt, type cfg to display the Configuration menu and prompt
(Configuration#).
3. Type the following to disable autonegotiation on a GigaSwift Ethernet port.
Replace portnumber with the Ethernet port used by the adapter.
4. Type the following to apply and save your changes.
Refer to the switch documentation for further configuration instructions.
>> Main# cfg
[Configuration Menu]
sys - System-wide parameter menu
port - Port configuration menu
ip - IP addressing menu
vlan - VLAN configuration menu
stp - Spanning Tree menu
snmp - SNMP menu
setup - Step by step configuration set up
dump - Dump current configuration to script file
>> Configuration#
>> Configuration# /port portnumber/auto off
>> Configuration# apply
>> Configuration# save